Anti-vibration Board For N7 Flight Controller

$15

N7 Autopilot Anti-vibration Board for N7 Flight Controller
The N7 Autopilot Anti-vibration Board is a professional accessory designed to work seamlessly with the N7 flight controller. Vibration and mechanical noise are among the most common challenges in drone operations. They originate from motors, propellers, and airframe structures, often interfering with sensitive sensors such as gyroscopes, accelerometers, and compasses. This interference can lead to inaccurate readings, unstable flight behavior, and reduced navigation precision. The anti-vibration board acts as a protective layer between the N7 flight controller and the drone frame, effectively absorbing and minimizing vibrations to ensure smooth and reliable performance.
Installation and Usage Tips
Ensure that the anti-vibration board is mounted flat and level for maximum efficiency.
Use proper screws, spacers, or rubber dampers during installation to avoid introducing new vibration sources.
After installation, perform a short test flight to check sensor data and confirm that vibration levels have been significantly reduced.

Technical Drawing


Specification
Model NO.	18.25.9(462.3149.9mm)	T-MOTOR Series	Foldable
Weight(Single Blade)	40g	Material	CF+Epoxy
Thrust Limitation	10kg	Ambient Temp	-40℃~65℃
Optimum RPM	3000-6000 RPM/min	Storage Temp/Humidity	-10℃~50℃/<85%
Surface Treatment	Glossy

Packing List


Note
1. Prop marked with “L” is for CW which “R” for CcW (aerial view). 2. Please be careful when using the propellers as the spinning propellers may cause serious injury. 3. The structural strength of the propellers are fully tested, please make sure the propellers are not used beyond the limits. Please do not tempt to test the strength of the propellers by bending them by hands. Any damage or loss from improper use will be on the users’account. 4. Please make sure all the accessories are mounted properly. 5. Please check on the propellers before flight and make sure they are in good condition. Please replace propellers with new ones if fault is found with them. 6. For storage, please keep them away from hostile environments including but not limited to that of H2 0, SO2,NO2，Cl2 , organosilicon, cyanogroup and phenol. Ambient temperature is recommended between 0 and 40℃ at less than 80% humidity. 7. Please apply anaerobic screw locking glue of medium or above strength when install propellers onto motors. 8. Please use the propellers in compliance with local laws and regulations.